Enersol Flomar Limited, Churchill Way, Fleckney, Leicestershire LE8 8UR
firstname.lastname@example.org Tel: +44(0) 116 240 3430
Registered in England, no 1735241 Reg Office: Churchill Way, Fleckney, Leicestershire LE8 8UR
Our steam audits are customised specifically for each individual client, and typically investigate areas from the following criteria:
Design of distribution system and condensate return system (steam traps, drop out points, pipe sizing etc)
This will show leaking or blocked traps. Losses are shown in kilograms per hour along with cost.
Consider automated blow down
Consider automated TDS control
Consideration givern to raising hotwell temperature vide steam injection and/or TDS recovery system. Other methods may also be considered, dependent upon the client’s installation.
Consider lagging and insulation options
Consider Replacing mechanical or linked burner controls with modern independent motor-
Consider fixed speed fans and motors with variable speed units
Consider reducing burner size on a boiler that consistently runs below optimum load
Consider sequencing multiple boilers using a boiler management system controlled by a plant management programme
Consider a load balancing system which will determine when an additional boiler should be brought online as well as which units will be most efficient at given total load.
Consider Operating ‘No/Lo Cost’ Operating Improvements
Consideration given to PM5, PM60 and Safed regulations
A report will be issued to the client and, depending on the breadth of the audit, will deliver the following information;
Cost of improvement
Return on investment (where applicable)
Efficiency percentage improvement
Benefits of Steam and Condensate System Audit.
If you’d like any further information or to discuss your particular requirements, please do not hesitate to get in touch with no obligation whatsoever.